Sunday, December 6, 2009

Holset Hx35 on a Built JDM 3SGTE swapped into a 1997 Toyota Celica GT.

I can’t believe I haven’t posted this sooner, I forgot all about my Celica’s dyno video.

Like the video says Mike Bruell & Myself made 330whp & 250wtq at 14.5lbs boost (1bar).

Here’s a couple drive by videos for your enjoyment.

I know it doesn’t look like I’m going fast but that last pass I hit 120mph easily.

In the 2nd pass you can hear the tires break free then 8,500rpm rev limiter.

Ok, and below just to show you guys the engine is now in the MR.

Heres a video of it RIGHT after I got it in the car, there was no exhaust, the timing was off and It hadn’t been tuned. So yeah I know it sounded like shit in the video but it was just to show

people I completed the swap. Since then everything and more has been done to that engine.

Thats going to be my next post ;)

The 91 JDM 3sgte 9.0:1 comp engine is built with these mods:

AEM Full Standalone Unit

Holset Hx35 Turbo

Forged 87mm CP pistons

Forged Eagle H-beam Rods

Balanced, Blueprinted, micro-polished Internals

Wolkatz Top Feed fuel rail

Aeromotive FPR 1.1

870cc Delphi Injectors

HKS 264 ex 272 in Cams

Eagle valve springs

RMR Intake Manifold

Heat resistant resin intake manifold gasket

70mm Mustang Throttle Body

Cometic head gasket

ARP headstuds

Custom 3″ V-band downpipe

Fidanza cam gears

Solid motor mounts

Aem Uego Wideband o2

Gm boost solenoid

Gm 3 Bar Map

Spec (clutchmaster) stage 3 clutch

HKS Super Mega Flow intake filter (actual name haha)

Apexi dual-drive blow off valve

12×12 Oil cooler

Canton Racing Oil relocation fitting.

3″ mandrel bent side exhaust W/ huge muffler & resonator

300×600x3″ Bar and Plate Front mount intercooler W/ 2.5″ to 3″ mandrel bent piping

Not bad power.

This was a break in tune so we didn’t turn the boost up, It was set to the wastegate spring, 1 bar.

Which is unfortunate because at 1 bar this turbo wasn’t even in its efficiency range yet.

Around 22+ lbs is were this turbo comes alive and really puts down power.

Currently I’m building a 2.2L stroker 5SGTE, 8:1 compression ratio.

With this turbo in my MR2, Plan to run 30lbs of boost on pump gas daily, but thats another post.

Anyways, don’t be afraid to leave me a comment.

Mike Bruell is a great tuner and is always up to the challenge of tuning vehicles.

If you would like us to tune your vehicle send me an email.Heres more pics of the celica.

[Via http://digitaladdict.wordpress.com]

No comments:

Post a Comment